Swimming pools are a great way to cool off during the hot summer months. But they can quickly become a breeding ground for algae, bacteria and other unwanted contaminants.
Luckily, Ultima Nix Algaecide and Phosphate Remover can help keep your pool clean and clear. Here's how to use it for optimal performance.
First, it's important to test your pool's water and adjust the pH levels to the ideal range of 7.4 to 7.8. If your pH level is too low, add soda ash to raise it. If it's too high, add muriatic acid to lower it.
Once the pH level is adjusted, it's time to add Ultima Nix Algaecide and Phosphate Remover. This product works by destroying the algae, bacteria and other contaminants in your pool. It's important to follow the directions on the bottle carefully, as too much or too little can be ineffective.
Start by adding the product directly to the skimmer basket. For pools up to 10,000 gallons, use the recommended dosage of one quart. For pools over 10,000 gallons, use two quarts. Allow the product to circulate through the pool's pump and filter system for at least two hours.
Next, brush the walls and surfaces of the pool with a stiff brush to loosen any algae or debris. This will help the product to penetrate and do its job more effectively.
Finally, run the pool filter for at least eight hours. This will help to remove any of the dead algae and other contaminants from the pool.
By following these steps, you can use Ultima Nix Algaecide and Phosphate Remover to keep your swimming pool clean and clear. This product is an effective and safe way to keep your pool free of algae and other contaminants.
If you have any other questions about pool and spa products please do let us know - we are here to help!
Also don't forget to subscribe to our YouTube channel and check out our videos with other great pool and spa products!
